From the Home page, tap "Add device" or the (+) in the top right corner.
Select Add Device. Choose Nooie Smart Plug.
Confirm that your plug LED is flashing white rapidly (twice per second), then go to the next step. If the light isn't flashing, please reset the plug by pressing and holding the power button for 5 seconds. For "Gen 2", make sure "Bluetooth" is enabled on the phone and select "NSP01 Pro" in the app.
Connect to WiFi, enter the password, and tap Next.
Connect via 2.4GHz WiFi (5GHz WiFi is not supported). Select Change to select a different network if needed.
Enter the WiFi password (special symbols in the WiFi password may cause a failure in connection).
Tap Next to connect the Nooie Smart Plug. This may take 90 seconds.
If the connection fails, you can try to connect using the AP (access point) mode by pressing and holding the power button for 5 seconds until the light flashes slowly (once every three seconds).
Connect to WiFi and then connect to the Nooie Smart Plugs' hotspot in your phone's settings.